Hi!
I am looking for advice on my DIY pond aeration set up. The two ponds are connected by a culvert when the ponds are full. Big pond is approximately 2.8 acres and small pond is 1/10 of an acre. As for depths, I only have estimates but I will try. Big Pond has a deep section around Diffuser 3 of about 20-30 feet. Small pond is 6-12' deep. Diffuser 2 and 4 will probably be 6 to 12 feet of water.
Here is what I cobbled together and I want your opinion if my idea is sound or completely wrong, lol.
1. Compressor
https://tinyurl.com/46jp73p32. Underground Airhose-
1" Pex
3. Diffusers--
I was having a hard time deciding between the kasco diffuser because of its efficiency vs the Vertex diffusers everyone here seems to love. Cast your vote below if you don't mind. I am leaning towards Vertex, but I am
not sure how many heads I should put at each station.
4. Manifold
https://www.amazon.com/Fawn-Lake-Manifold-Stainless-Aluminum/dp/B0893FQYJ5?th=1 I wanted to keep an extra port open in case of expansion
5. Air Hose
I am planning on 1/2" ID self sinking
6. Compressor House
I was just going to build my own, insulate it, and have a fan blowing at the compressor
Length of Airhose Runs
From Compressor to Manifold- 300'
From Tee to diffuser 1---100'
From Manifold to Diffuser 2 ----165'
From Manifold to Diffuser 3---- 325'
From Manifold to Diffuser 4----137'
Also, does anyone have a good recommendation for pond dam repair. There is a seep on one part of the dam.
Thanks for whatever help you can give!
