Originally Posted By: ewest
Have holes in all pvc so water can get in and air out.


The hose will be in the PVC holes so aire should be able to escape easily.

Originally Posted By: ewest
Have it so you can attach a few cross pieces to the hoses. Vary the hose length so some are higher (example all center pieces a foot longer - a 3-D effect - not a flat top).


I'm not sure what you mean here. How would I attach cross peices to the hoses?

How would making the center peices a foot longer create a 3D effect?

I'm thinking about making the hose located furthest from the bank a little longer. This will make it such that the hose is about 3 feet below the water at full pool to allow more water fluctuations. Making the hose further out longer will offset the downward slope of the pond.

Thanks for your help! It's hard to explain based off a sketch but I wanted to run this past you guys first since it will be pretty expensive.

Thanks again!

I want to grow 10 lb'ers!!!