Pond Boss Magazine
https://www.pondboss.com/images/userfiles/image/20130301193901_6_150by50orangewhyshouldsubscribejpeg.jpg
Advertisment
Newest Members
TraceyJo4, Ben906, ely, Fishingadventure, Kowalski Home
17,723 Registered Users
Forum Statistics
Forums36
Topics39,687
Posts540,056
Members17,725
Most Online3,583
Jan 15th, 2020
Top Posters
esshup 26,633
ewest 20,961
Cecil Baird1 20,043
Bill Cody 14,236
Who's Online Now
13 members (ely, azteca, thatdoggjake, Bill Cody, optimalfishfood, Qetjustin, tim k, Bobbss, DrLuke, Auprospector, catscratch, al allison, Bing), 373 guests, and 149 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Joined: Dec 2021
Posts: 3
W
OP Offline
W
Joined: Dec 2021
Posts: 3
Hello everyone, this is my first post on the forum and after lurking for months I decided to say hello and become part of the community. I own a 50 acre farm in NW Florida that used to grow peanuts, and on one side there are two hills that form a small valley and stream that flows with any rain at all. I decided to build a 1-acre pond in the middle of this area for a couple of reasons. The ground there stays muddy and is hard to work so I figured it was a great spot for a pond. After having several quotes of $25-40,000 I have decided to build the pond myself. I have a 30hp John Deere with an FEL and a box blade, and so far I have been using the box blade to move all of the topsoils to the sides. Under the topsoil is really nice red clay, very compacted, very hard, and should make a good liner. The high end of the pond is about 6-8 feet higher than the low side, and I plan on making it a kidney shape where the rounded side of the kidney is about 65% dam. My question so far is, should I start the core trench at any elevation change at all, or is there a certain depth where I should begin putting a core trench in? It's a pretty gentle slope, so I was unsure where to start digging the trench. Thank you for any help!

Joined: Nov 2007
Posts: 1,454
Likes: 237
F
Lunker
Offline
Lunker
F
Joined: Nov 2007
Posts: 1,454
Likes: 237
Usually when working with an existing topography that is conducive to building a pond, there will be a certain elevation that is the least amount of work to create a pond of X acres. I would determine that elevation first, to plan your "normal pool" water elevation level.

The acre-feet of water in the pond design must also be calibrated to the upstream watershed, rainfall amounts for your area, surface use of the land in the watershed, etc. Too little water coming into the pond is bad because it will be difficult to keep your pond a normal pool. However, it is also bad to have too much water coming into the pond.

You might actually be better off with a LARGER pond in the latter situation.

Here is a link to the old USDA Pond Planning Guide:

https://www.nrcs.usda.gov/Internet/FSE_DOCUMENTS/nrcs144p2_030362.pdf

That is a very useful resource at your stage of the pond design.



It is awesome that you have good clay below the topsoil!

(Make sure you stock the topsoil so that it can be easily placed over your clay final grades that exist outside of the pond. For example, the disturbed shorelines above the water level and on the backside of the dam. It is much easier to re-establish groundcover vegetation on good topsoil compared to compacted clay.)

Good luck on your new project, and welcome to Pond Boss!

1 member likes this: Wild Flower Farm
Joined: Dec 2021
Posts: 3
W
OP Offline
W
Joined: Dec 2021
Posts: 3
Thank you for the advice, it is much appreciated. The gentlemen I had come give me quotes actually helped me map it out, the portion that is below the higher elevation is probably 30% of the total bank. Also, I think the guys who gave me quotes realized I wasn't about to spend that much on a pond and gave me some really good advice on a plan of attack. I split the topsoil down the middle and spread it to the bank of the pond on either side, so covering the grade should be pretty easy. I also left 20 feet on either side of where I want my dam to start piling up the fill from both sides. Having finished moving the topsoil today, I plan on starting to push all the clay towards the dam, but my concern is the trench. Would making the vast majority of the dam out of clay itself still require much of a core? Or just a trench below the base with compacted clay? The pond has about 5 acres of total watershed, and from what the professionals said, I figure that should be enough for a 5-7ft pond with a few deep spots. Thanks again!

Last edited by Wild Flower Farm; 12/03/21 04:49 PM.
Joined: Nov 2007
Posts: 1,454
Likes: 237
F
Lunker
Offline
Lunker
F
Joined: Nov 2007
Posts: 1,454
Likes: 237
Are you near the Chipley in the Florida panhandle?

5 acres of watershed in an arid region is not enough for a 1 acre pond. 5 acres in Florida is a much more abundant supply of water!

You are going to have to design an emergency spillway due to your chance of a hurricane level rain event in your watershed.

What equipment are you using for your compaction?

1 member likes this: Wild Flower Farm
Joined: Dec 2021
Posts: 3
W
OP Offline
W
Joined: Dec 2021
Posts: 3
I am in Chipley, Fl. I will take the spillway into consideration, there is a large area 100 ft from the edge of the where the dam will be that is swamp and wetlands extending for a lot of acreage, 50-100 or so of swamp and washed out creek bed. So I could do an emergency spillway into that, as it already collects a lot of water around us, and most of the natural runoff of where I am digging. So I think it might dry the area up a bit until the pond overflows. As for compaction, I only have my JD 3032, I thought about just running the box blade all the way down over and over, but not sure if that would be enough. I might rent a skid steer, or if it really comes down to it, I might have to pay someone for a couple of days of dozer work for that part. Thanks!

Joined: Jan 2022
Posts: 3
Likes: 1
H
Offline
H
Joined: Jan 2022
Posts: 3
Likes: 1
I’m new to the forum but built exactly what your wanted my self a few years back.
2 words of advice that you do with what you like.
I’ve killed 2 3032 johndeeres. Great tractors but heavy work like that will destroy the hydro transmission ( I don’t think they make a Manuel) if they do I can’t speak of its quality.

You can rent a dozer for slightly more then a skidsteer and you will be way more productive.
I own a 333G skidsteer which is big as they come. After 12 hours I realized I needed a dozer.

As for the dam I used a track hoe and dozer.
My dam is 4’’ tall and core trench is 2’ deep.
My pond is 10’ deep.

1 member likes this: gehajake
Joined: Aug 2012
Posts: 77
Likes: 1
Offline
Joined: Aug 2012
Posts: 77
Likes: 1
Don't hesitate to reach out to TJ. He is so willing to give of his time to talk thru problems or ideas on your pond -and not even necessarily to do with Soil Floc use and application. He has lots of experience and knowledge and will treat you like he has known you all of his life.


1 member likes this: 4CornersPuddle

Link Copied to Clipboard
Today's Birthdays
Buzz Tatom, North40
Recent Posts
Cypress questions
by Auprospector - 05/22/22 04:27 PM
Bladderwort Control
by TraceyJo4 - 05/22/22 03:28 PM
Hiawassee Georgia Pond!
by Troutguy1 - 05/22/22 02:30 PM
Feed with the flies.
by azteca - 05/22/22 01:12 PM
At a loss - pond won’t hold water.
by Ben906 - 05/22/22 12:06 PM
Innovative feeding technique
by jpsdad - 05/22/22 11:36 AM
A new pond journal.. lets see where we go!
by CrazyCarl - 05/22/22 11:25 AM
All HBG & Bass Missing: Help Please!
by FishinRod - 05/22/22 11:18 AM
Game fish shortage in Michigan?
by FishinRod - 05/22/22 10:44 AM
Fish Feed Questions
by FishinRod - 05/22/22 10:39 AM
Neat gate for certain situations
by esshup - 05/22/22 08:49 AM
Guadalupe Bass
by esshup - 05/22/22 08:44 AM
Newly Uploaded Images
pond 6
pond 6
by Stressless, May 10
Molly Ann surveys her new Puppydom
Molly Ann surveys her new Puppydom
by Mongos Pond, January 28
Fry
Fry
by CityDad, January 20
Baldcypress
Baldcypress
by Stressless, January 11
Still active
Still active
by Shorty, December 15
Using FishMap
Using FishMap
by Stressless, December 9

� 2014 POND BOSS INC. all rights reserved USA and Worldwide

Powered by UBB.threads™ PHP Forum Software 7.7.5