Pond Boss Magazine
https://www.pondboss.com/images/userfiles/image/20130301193901_6_150by50orangewhyshouldsubscribejpeg.jpg
Advertisment
Newest Members
Shotgun01, Dan H, Stipker, LunkerHunt23, Jeanjules
18,451 Registered Users
Forum Statistics
Forums36
Topics40,902
Posts557,132
Members18,452
Most Online3,612
Jan 10th, 2023
Top Posters
esshup 28,422
ewest 21,475
Cecil Baird1 20,043
Bill Cody 15,112
Who's Online Now
11 members (Boondoggle, Sunil, Bill Cody, FishinRod, Augie, Jason D, PRCS, Shorthose, Brett B, Layne, Angler8689), 948 guests, and 220 robots.
Key: Admin, Global Mod, Mod
Previous Thread
Next Thread
Print Thread
Joined: Nov 2020
Posts: 3
J
OP Offline
J
Joined: Nov 2020
Posts: 3
Hello everyone, I’m new to the forum. My dad and I have a 1.5 acre pond and a 1 acre pond. My current issue is with the 1.5 acre pond. Well, I don’t yet have an issue, just looking to the future to prevent future problems. I apologize if the post includes a topic that should be in a specific sub forum. Moderators feel free to reprimand me if needed.

The details. Pond is 5 years old and is spring fed. The potential issue I have is that when the pond was dug, a corrugated poly 12 inch pipe was installed at about a 30° angle front to back. My worry is when this poly corrugated pipe cracks or fails, it will ruin my dam and/or drain the pond. Like most people, I don’t want to spend a ton of money to repair a future problem so I want to solve it before it happens. I have spent the summer fortifying the dam and adding approximately 2 feet to the elevation. I have made an emergency overflow do direct overflow to the undisturbed Bermuda covered side of the pond dam with a gradual slope.

Long story short, I want to plug this pipe and only have a “emergency” overflow as my only outlet. I know that may be a no no, however, if I run into erosion issues, after plugging, I plan on installing a horizontal pvc pipe with riprap and matting for erosion control. What is the best way to plug this pipe permanently so I don’t have to worry about it. Digging the pipe out makes me nervous because I really don’t want to take a chance on compromising the integrity of a super tight pond with no current issues. Any ideas would be appreciated!

Thanks I’m advance.

Joined: Nov 2007
Posts: 3,251
Likes: 584
F
Lunker
Online Content
Lunker
F
Joined: Nov 2007
Posts: 3,251
Likes: 584
Jase,

Check your corrugated 12" poly pipe again. Is it dual-wall 12" culvert? (It would look smooth on the inside, not corrugated.)

If it is dual-wall culvert, then that stuff is pretty tough. Further, even if it cracked, it should be mostly in packed clay. I think the preferred path of the water would still be down the pipe, rather than working around the outside of the pipe and washing out your dam.

Just my two cents. There are lots of actual dam building experts in the forum. Hopefully, one of them will come along and address your concerns.

Good luck!

Joined: Jan 2006
Posts: 16,028
Likes: 274
D
Moderator
Lunker
Offline
Moderator
Lunker
D
Joined: Jan 2006
Posts: 16,028
Likes: 274
Any way to cap the pipe? I do stuff like that often with PVC. You MIGHT be able to use a PVC cap and caulk or epoxy around it.


It's not about the fish. It's about the pond. Take care of the pond and the fish will be fine. PB subscriber since before it was in color.

Without a sense of urgency, Nothing ever gets done.

Boy, if I say "sic em", you'd better look for something to bite. Sam Shelley Rancher and Farmer Muleshoe Texas 1892-1985 RIP
Joined: Nov 2020
Posts: 3
J
OP Offline
J
Joined: Nov 2020
Posts: 3
Sorry for the long gap in reply. I haven’t figured out how to subscribe to a thread. It is a single wall pipe. I could probably cap it. I just want it to be as permanent as possible.

Joined: May 2009
Posts: 5,714
Likes: 281
R
RAH Offline
Lunker
Offline
Lunker
R
Joined: May 2009
Posts: 5,714
Likes: 281
Does the pipe show signs of degradation?

Joined: Nov 2020
Posts: 3
J
OP Offline
J
Joined: Nov 2020
Posts: 3
RAH

No, there is no sign of degradation, but I have been flexing the inlet end up and down slightly to regulate the level of the pond. Maybe 10 inches up and down.

Joined: May 2009
Posts: 5,714
Likes: 281
R
RAH Offline
Lunker
Offline
Lunker
R
Joined: May 2009
Posts: 5,714
Likes: 281
If it is moving that much, it seems like the dam may not be packed properly around the pipe. Is the dam leaking around the outside of the pipe?


Link Copied to Clipboard
Today's Birthdays
cro, HC1968
Recent Posts
Relative weight charts in Excel ? Calculations?
by jpsdad - 03/29/24 09:57 AM
Can anyone ID these minnows?
by jpsdad - 03/29/24 09:19 AM
pond experience needed
by esshup - 03/29/24 08:19 AM
Dewatering bags seeded to form berms?
by RogersTailgate - 03/29/24 05:45 AM
New pond middle TN: establishing food chain?
by Bill Cody - 03/28/24 07:57 PM
Happy Birthday Bob Lusk!!
by FireIsHot - 03/28/24 07:33 PM
Working on a .5acre disaster, I mean pond.
by PRCS - 03/28/24 06:39 PM
Fungus infection on fish
by nvcdl - 03/28/24 06:07 PM
1 year after stocking question
by esshup - 03/28/24 04:48 PM
Yellow Perch Spawn 2024
by H20fwler - 03/28/24 04:29 PM
New 2 acre pond stocking plan
by LANGSTER - 03/28/24 03:49 PM
Newly Uploaded Images
Eagles Over The Pond Yesterday
Eagles Over The Pond Yesterday
by Tbar, December 10
Deer at Theo's 2023
Deer at Theo's 2023
by Theo Gallus, November 13
Minnow identification
Minnow identification
by Mike Troyer, October 6
Sharing the Food
Sharing the Food
by FishinRod, September 9
Nice BGxRES
Nice BGxRES
by Theo Gallus, July 28
Snake Identification
Snake Identification
by Rangersedge, July 12

� 2014 POND BOSS INC. all rights reserved USA and Worldwide

Powered by UBB.threads™ PHP Forum Software 7.7.5