Another Configuration Advice thread . . . - 06/23/20 09:58 PM
We have a 5-year-old pond, about 14,000 SF, 19' at the deepest. We're having a bore run out to the dock, which is about 275' from the house, running 220 VAC to a subpanel. The aerator will sit next to the panel, and pending the collective wisdom, I'm about ready to order a Matala LP1 kit (definitely open to advice here, though). We'll also have a couple of 110 VAC spurs run out from the subpanel to GFIs, and a couple of GFIs on the dock. The deepest point of the pond is probably 20' off the dock., and thus 25' from the compressor. I'm not presuming any particular benefit from the 220 VAC compressor (if there's a significant delay in getting the 220, I might just go with the 110), and of course the service conduit will go into the subpanel, and all will be done by an electrician.
Do I seem to be missing anything, and is there any other compressor I should study up on?
Thanks much,
--RIck
Do I seem to be missing anything, and is there any other compressor I should study up on?
Thanks much,
--RIck