|
|
|
Forums36
Topics42,115
Posts571,695
Members19,116
| |
Most Online45,564 17 hours ago
|
|
|
1 members (RichardinFL),
6,961
guests, and
153
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
| by CentexSaj |
| CentexSaj |
Not sure where to post this question but my property has a wet weather creek that runs in the very back of it. I never looked at it seriously as a water source for my pond but after our last rain a week ago I've been monitoring it, and the creek is still running. Has anyone tried to pump water from a wet weather creek before? The creek naturally pools on my property, I think it holds maybe a 1/4 acre ft of water, maybe less but the flow rate is still good enough to likely fill it back up with in 24 hours. Given that I'm only going to be building a 1 acre tank this doesn't sound like an insignificant amount of water. My thoughts would be to get a submersible pump with a float switch so that it would turn on once the creek had water in it. The negative is that during a heavy rain this creek can really flood, so whatever I put down there needs to be able to withstand a good amount of flood water or else it will just be swept downstream. Looking for any advice.
|
|
|
|
| by CentexSaj |
| CentexSaj |
Sorry for the late response.
So, I actually own several gas trash pumps as we do a lot of pumping from creeks to flood duck impoundments. This is typically a dry creek, so to get the most benefit out of it I need a pump that can start up as soon as there is water, and then be able to shut off when its pumped dry. I'm not going to be able to be out at the property and constantly monitor this so an electric pump with a float switch seems to be the only reasonable way to go.
I like the ideas to build a sump, it will offer a lot of protection to the pumps and actually not cost much at all to build.
We just had a major rain event and over all, I'm not very worried about this pond filling up. I was finally able to study where water was flowing around my property and the neighboring properties, and it appears that we have way more runoff than we need. I'm actually going to maybe redesign the pond a bit because I'll likely have to reinforce the spillway. The issue with my area however is we keep going into droughts and we get very little rain during the summer. So these pumps will really help out to maintain a constant level.
Esshup, the barnes pumps are estimated to do 8400 GPH at the 8-10' head height that I told the guy we would be pumping up to.
|
| 1 member likes this |
|
|
|
|
|