|
Forums36
Topics42,113
Posts571,673
Members19,115
| |
Most Online13,561 9 hours ago
|
|
|
|
Joined: Jan 2009
Posts: 29,788 Likes: 1295
Moderator Ambassador Field Correspondent  Lunker
|
|
Moderator Ambassador Field Correspondent  Lunker
Joined: Jan 2009
Posts: 29,788 Likes: 1295 |
Its about 3/4 acres surface area right now . normally around 1/2 + i guess. It was dug in 2004 i believe and was holding about 4’ or 5’ of water when I bought my house . I have been trying to rehab it for 4 years by pumping it out during dry seasons and tilling in a few tons of bentonite at a time where my probe would sink in further than other areas. I know I need about 50 tons to cover the entire basin at 6 lbs per sq ft but can’t afford 2 semi loads at 10k .I rented a Huge Bomag sheepsfoot compactor and ran that over it for 10 hrs a few weeks ago and its still leaking but not as much i think. i need to put a measuring device out there to be accurate. I can probably keep it full with my dedicated well but the neighbor keeps complaining he has to wear muck boots to do his lawncare lol😂His house is about 3-4 hundred ft across other side of asphalt road with bar ditches on each side. Says the water must be coming up from the ground because of my pond. How could he prove that? Just that when my pond is full his lawn is swampy. Low pond level his lawn is dry. The pond was dug in 2004. How long have you owned the house and how long has he owned the house? When did this problem start? Oklahoma has had record rains in the month of April. If you are in the area of record April rains, and this is the first time that it's happened, then I would talk to a land attorney first to see where you stand before doing anything else. Without knowing that, all I can say is that the fluroescent dye to see if your pond water is causing the issue is a good idea (but only after talking to a land attorney). I would make sure that he doesn't know what color dye you are going to use just in case he gets some of the same dye to make sure that it shows up on the test........... I'd talk to TJ here on the forum. He has a polymer sealer that works better than bentonite. I'd do that before doing any more work on the pond..
|
|
2 members like this:
FishinRod, 4CornersPuddle |
|
|
Moderated by Bill Cody, Bruce Condello, catmandoo, Chris Steelman, Dave Davidson1, esshup, ewest, FireIsHot, Omaha, Sunil, teehjaeh57
|
|