So, I’ve installed the iso drip, confirmed that I had it installed correctly, sent a video to make sure, and the only thing that I/we can think of is that the line is pinched. I have the line leaking more air than ever before and it’s still setting off the prv.
Btw what happened when I set the iso drip up.. I turned it on, watched the gauge go over max, the iso poured into the line (don’t know how much but it was a few seconds worth) the prv was going off, and then I turned the unit off. I disconnected the iso drip and reconnected how I had it previously. But now it’s getting set off worse than ever.
Luckily I have a hole open from when it was “working” decently.. and now since it’s warmed up it’s still open but even with this warmer weather it is still burping with a pretty decent amount of air being bleed off. The only thing I can think of is the line is now being crushed by water weight. I don’t think I’ll be able to tackle that issue until spring/ summer. Big bummer.
