It finally got warm enough for me to put on a swimsuit and figure this thing out.

Elevating the pipe didn't help determine anything as water just leaked around the corrugated pipe ... must be a hole in it near where it comes out of the earth, which makes sense because it was supposed to be only temporary, and I think I nicked it with the excavator a couple times.

But based on y'alls thinking, I started messing around with my plug. Turns out it wasn't 100% plugged. I dove down 8 ft and put some plastic bags around the plug, and that slowed the flow from one beer mug ever 5 seconds to one beer mug every 14 seconds. So I started looking around for an even better sealer. I found some kitty litter in the cabin I had used to mix with Portland to grout my well. I mixed it with a little water, balled it up, and dove down to stuff it around the plug. Fixed. 100% sealed. Thanks for all the help.

Now I need to figure out whether I want to keep this as a way to drain the pond or if I want to abandon it. If I abandon it, I'll probably reconnect the old part of the riser to bring it above water level, then pour the mix of Portland and kitty litter until it's full.

Last edited by crazyj; 04/19/17 06:57 AM. Reason: Autocorrect