Through the holes on cinder blocks. 3 maybe 4 blocks......1 10-15ft out from the bank and 1, 2ft away from the splitter, (maybe 1 or 2 in the middle). I would glue all the PVC sticks together to create my run. I would take my 60ft run and motor boat out to where I think it would be centered in the pond and lower the splitter/3 way/hoses with a block on it via looped string. Then from the bank take each block and run the pipe through the hole and slide it out to its desired spot using a string on the block. Essentially sliding it along over the pipe. Run the PVC through each block and take it toward the spot I think its needed. Essentially creating 3 to 4 PVC anchors working middle, back to bank adding 1 block at a time. I think of it like adding beads to a necklace. Over time I figure my blocks would sink slightly into the ponds bottom become part of the pond and becoming more solid as time goes on.
I thought about using spray expansion foam to seal the PVC inside each block, but didn't want to introduce that chemical into my water.
Last edited by For the Family; 01/03/17 04:26 AM.
