Back to work on the truck after finishing most of the spring season runs.....I really wanted to have used this ready to roll for the season, but I'd rather have it built right, than fast!

I may have to re-think using the same tires on the tag as the main drive axle just so I could have a couple spares if needed. Low Profile tires on the lift axle would give me a little extra ground and cat-walk clearance. The frame is painted, the rear-end/bumper cut, pre-formed and ready to weld up. Entire drive line has been gone over well and anything showing even minor wear, replaced (very little replaced).

Once the final cat-walk is finalized on fab work and installed, the bed stretch will be seamlessly blended in, tanks will be set and the rest will be finishing touches for the fab shop, such as lighting, graphics, generator install and underbody storage boxes. I will do all the final setups for oxygen delivery, Low Oxy/pressure alarm, cab electronics/monitoring and a few personal touches.