I think each Vertex diffuser should take all the air direct from the compressor with 0 back pressure. Ask Ted to connect one of his single diffusers to a 4cfm pump and see what his psi reading is. IMO pressure should be 0 not 10psi. Something seems wrong with this picture IMO. A normal Vertex diffuser should not cause that much back pressure. The only way the psi should be 10 for one diffuser is the holes/slits are smaller than 1 millimeter and too few of them on the membrane.
Snrub thanks a lot for the link to the Thomas compressors. Very helpful.
Last edited by Bill Cody; 04/29/14 05:00 PM.
