Okay, I finally got some pics for you. Here they are, with questions.
First, a picture of my little pride and joy. The concrete has worked to block the culvert.
First question... how to I wire this pump, this is how it came, with no directions. The first pic shows how I *think* it goes (note the two wires connected to the capacitor). I'd spice the two black and the green (ground) to an old extension cord and plug the other two into the capacitor. The other pics are for your advice...
Next, I'm trying to setup an old well pump to run water from a small pool at the far end of my blocked off culvert that is always full of water (high water table) back up the spillway I just dug. Here is a pic of the spillway and the old pump. I've had it running and it shoots a stream of water like a powerful spitter through a nozzle into my large pond. Am I insane? Will this waste a ton of money?
