Honestly myself. I would drive down same size pipe right up against the rotted ones (or all of them). Then connect the old pipe to the new pipe by drilling completely through both of them and bolting them. If you have spots that need new angle iron put the 2 new post on the inside of the exisisting pipes so you could run the angle from new post to new post.. Kinda hard to explain. I would think this would be the easiest and most efficient(cheap) way to fix this problem.. If you need to pm me i could try to explain better.

I believe in catch and release. I catch then release to the grease..

BG. CSBG. LMB. HSB. RES.

[Linked Image from i90.photobucket.com]