Pond Boss Forums INTRO Questions & Observations low volume pump

Hi All,
I have a small (20 ft diameter, 8 ft deep) swimming pond. It's unlined, and I struggle to keep the water as high as I like throughout the summer. This past fall I installed a drilled well on the property for drinking water and had amazingly good results. In addition to good supply of drinking water, it's "artesian"...meaning that it has enough flow and pressure that an excess of about 2 gpm overflows from the well. The overflow is diverted through a small pipe and exits into a swale about 15 feet below the level of the pond. I'd like to install a small "cistern" of sorts at the overflow and use a small pump to move this excess water into the pond. Do any of you have a recommendation for what type of pump I should be looking for that is low flow....only need 2gpm....but has enough oomph to overcome the 15 foot head?

Welcome to the forums Kevin, you have a great looking place!

The most common pump for this application will be the traditional sump pumps that you find in basement sumps or septic lift systems. But, when you find one that can handle 15 foot of head, the GPM is typically much more than you need. This application would require float switches to handle the differences between the variable well flow and the output of the pump. It is practicality impossible to match the well flow to the pump flow without adding substantial cost to the control system.

My advice would be to make the sump (or cistern) as large as economically possible and place the sump pump at the bottom with a 'ON" float switch as close to the top as possible and the "OFF" float switch just above the pump.

Imagine a five gallon bucket as your cistern with a pump that puts out 10 to 20 GPM.., the pump would be cycling on and of every few minutes. This uses more electric than cycling less frequently. Now, imagine a 100 gallon cistern with the same pump. At 2 GPM well flow, your pump would only kick on every 50 minutes and have the cistern empty in just a few minutes.

I would suggest contacting a local septic service company for the right pump and float switch configurations. If you decide to go with a smaller pump than they have available, they should still be able to help with the float switches.

Here is an example of the type of pump I am thinking off....

McMaster Carr # 4182K5

https://www.mcmaster.com/4182k5

This supply company tends to cater to companies that need it tomorrow and tend to be on the high cost side, but their site is a great reference for things like this.

I'd suggest using a pump designed for the correct amount of head feet, but operated via a float switch.

I have a well about 33 ft deep close to my pond that I have been using for supplementation. I found these dc pumps on ebay that are perfect for that type of application. They are brushless so they have a really long life and dont take much power at all. You could use solar but I use a 24v laptop power supply and it works fine. I screw a small filter on the end just to be safe but no problems yet and they arent too bad as far as price if you burn one up or something. Cost to run is no more than having your laptop plugged in. Link below. Good luck.

https://www.ebay.com/itm/High-Pressure-P...mp/291586889066