Pond Boss Magazine
http://www.pondboss.com/images/userfiles/image/20130301193901_6_150by50orangewhyshouldsubscribejpeg.jpg
Advertisment
Newest Members
skirton, tgarner, JamesG, 337Bryan, MRaymond
16242 Registered Users
Forum Stats
16243 Members
36 Forums
37185 Topics
506494 Posts

Max Online: 2022 @ 10/09/19 11:25 PM
Top Posters
esshup 24034
Cecil Baird1 20043
ewest 20000
Dave Davidson1 14112
Bill Cody 12994
Who's Online
11 registered (teehjaeh57, RAH, JKS3613, roundy, KingRace78, canyoncreek, Augie, DrLuke, dreams of ponds, wbuffetjr, ItalyBASS), 420 Guests and 551 Spiders online.
Key: Admin, Global Mod, Mod
Topic Options
#508538 - 07/06/19 10:09 AM Circulation from well pump?
SmithMilitia Offline


Registered: 04/17/19
Posts: 9
Loc: ALABAMA
I have a 1.5 acre pond that is feed by a 180' deep well 1.5 hp pump that flows about 30-40gpm it comes in on one end of the pond at about water level. The pond looks very clean and fish are very healthy but I would like to get more circulation as the water seems really warm on the top and is probably not near the bottom. I just finally got the well pump replaced yesterday and am topping off the pond the about 2-3 feet it was low. It was filled a couple months ago just from rain but this will keep it full all the time and keep fresh water coming in. Anyway to my question do you think if I make the 2 inch line taper down or add a valve to up the pressure or add a spray bar etc I can get the circulation of the water up without adding aerators? Have any of you done this or maybe added a line to make a large sprayer?

Thanks in advance

Top
#508545 - 07/06/19 06:17 PM Re: Circulation from well pump? [Re: SmithMilitia]
Snipe Offline


Registered: 10/26/18
Posts: 731
Loc: NW Kansas
I have a similar situation at my pond. I added a venturi to my main line-also 2"- to suck a bit of air into the low DO water, but I don't want my temps equal top to bottom. Mine is about 11.5' at the deepest, full-pool and my main line comes in and is anchored in 7' coming straight up about 1' off of bottom. I can also run 120gpm open flow and it's quite a boil.
I still decided it best to buy an aerator and run night cycles only in the heat. I think it's helped my water quality substantially.


Edited by Snipe (07/06/19 06:18 PM)
_________________________
I Subscribe!

Top
#508964 - 07/16/19 10:41 AM Re: Circulation from well pump? [Re: Snipe]
Kris B Offline


Registered: 04/14/19
Posts: 39
Loc: Lafayette, LA
How did you setup your venturi into the well feed line, just a tee with a vertical air draw?
_________________________
Kris

I subscribe to Pond Boss Magazine

Top
#509013 - 07/17/19 08:49 AM Re: Circulation from well pump? [Re: SmithMilitia]
TGW1 Offline


Registered: 09/19/14
Posts: 2926
Loc: Harrison Co. Texas
I have a 2" line from my water well that produces around 50 gpm and I drilled a hole in the top side of the line and then set a half inch six inch long pipe into the hole to where it will suck air into the water line and feed the water. You can actually see the difference in the water/air mixture as it comes out of the water line simply by putting my finger over the small piece of pipe.
_________________________
Do not judge me by the politicians in my City, State or Federal Government.


Tracy

Top
#509045 - 07/17/19 10:45 PM Re: Circulation from well pump? [Re: TGW1]
Kris B Offline


Registered: 04/14/19
Posts: 39
Loc: Lafayette, LA
Great, thanks! Hopefully my pond will be refurbished and filing up in the next month or two, and I'd like to suck a little oxygen in as I fill it up!
_________________________
Kris

I subscribe to Pond Boss Magazine

Top
#509048 - 07/17/19 11:20 PM Re: Circulation from well pump? [Re: SmithMilitia]
Snipe Offline


Registered: 10/26/18
Posts: 731
Loc: NW Kansas
Kris, I meant to take a pic of mine today but I forgot while there.
I tried several combinations of sizes and I ended up using a reducer from 2" down to 3/4", 6" of pipe then back to 2". At the down stream end of 3/4" I drilled a hole for a carbon arrow shaft sticking straight up, angled the end and glued in place so the shaft was centered in the flow. You can hear it sucking air 100yrds away. Creates a hell of a boil..
_________________________
I Subscribe!

Top
#509413 - 07/26/19 01:04 AM Re: Circulation from well pump? [Re: Snipe]
Kris B Offline


Registered: 04/14/19
Posts: 39
Loc: Lafayette, LA
Wow! Sounds like it's doing the job, but can't say I want to be hearing the sucking sound when it's running! I'm planning to put the well pump on a float switch... I'll have to think more about that one. Thanks again for the input!
_________________________
Kris

I subscribe to Pond Boss Magazine

Top

Today's Birthdays
Brandon Unrein, Larry McDavid, Ninmaxx
Recent Posts
I think there is a fungus among us.
by teehjaeh57
0 seconds ago
Turning a pontoon into a dock
by roundy
26 minutes 53 seconds ago
Got a nice one Saturday!!!
by RAH
47 minutes 34 seconds ago
What did you do at your pond today?
by canyoncreek
Today at 03:54 PM
Bob Lusk's Call For Comments on PBMag Changes
by Bill Cody
Today at 03:52 PM
Tilapia Winter Death 2017?
by Bill Cody
Today at 11:53 AM
2nd generation LMB in new pond?
by ewest
Today at 11:26 AM
8/10 acre pond with 1,500 HBG - Now what
by TGW1
Today at 09:54 AM
Best Muck Reducer
by liquidsquid
Today at 09:50 AM
How to control Southern Naiad (Bushy Pondweed)
by TGW1
Today at 09:42 AM
Newly Uploaded Images
Need Plants Identified - Texas Pond - Lily Pad ...
Personal Record BGxRES
Harry's Pond
pond view
Fishing Colorado...finally
Releasing a quick snack

2014 POND BOSS INC. all rights reserved USA and Worldwide