Pond Boss Magazine
http://www.pondboss.com/images/userfiles/image/20130301193901_6_150by50orangewhyshouldsubscribejpeg.jpg
Advertisment
Newest Members
B-rad, Cheryll, Steve Smewing, bcraley, Dale-r1
15413 Registered Users
Forum Stats
15414 Members
36 Forums
35561 Topics
484883 Posts

Max Online: 1039 @ 03/28/13 02:44 PM
Top Posters
esshup 24027
Cecil Baird1 20043
ewest 19346
Dave Davidson1 13364
Bill Cody 12366
Who's Online
20 registered (John Fitzgerald, Bobbss, snrub, anthropic, Redonthehead, highflyer, Twar, SteveC, JustinV, Mike Whatley, NEDOC, Bob-O, Pat Williamson, Cheryll, Bing, Jimmi, sprkplug, tommyt, scott69, Zgrig81), 253 Guests and 489 Spiders online.
Key: Admin, Global Mod, Mod
Page 2 of 2 < 1 2
Topic Options
#482632 - 11/13/17 04:47 PM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: snrub]
John Fitzgerald Online   content


Registered: 10/27/15
Posts: 1893
Loc: S. end of Elkins, Arkansas
If it's cranked down, it's probably a gate valve. There may be a piece of debris under it, and opening it a little bit may dislodge the debris, allowing the valve to close fully.

If it's 12 inch SDR 26, I have a few scrap pieces of that, and it's pretty thick and double gasketed at the bells. Rated for forced sewer mains at a maximum of 160 PSI. If it's SDR 35 or higher, it's not rated for pressure, but gravity feed only.
_________________________

Top
#482634 - 11/13/17 04:59 PM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: John Fitzgerald]
snrub Online   content


Registered: 10/05/13
Posts: 4725
Loc: SE Kansas
SDR35 is what my ponds have for overflow pipes. I would imagine the 400 feet of drain would not require pressure rated pipe, but they may or may not have used it.

He said a flapper valve operated by a pull lever. If that is the case I would think it might be a smaller valve like maybe a 4 or 6 inch. I can't imagine a 12" flapper valve as the amount of pull to initially open it would not be practical.

We are still trying to read between the lines of the design but my best guess now is that the flapper valve is smaller then the drain pipe is 12".




Edited by snrub (11/13/17 05:00 PM)
_________________________
John

I subscribe to Pond Boss Magazine

Top
#482635 - 11/13/17 05:26 PM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: djwoodman]
John Fitzgerald Online   content


Registered: 10/27/15
Posts: 1893
Loc: S. end of Elkins, Arkansas
I looked online, and cannot find a flapper valve larger than 4 inches. They are listed as check valves. I cannot imagine why an engineer would spec a flapper. Most, if not all small lakes that have valve towers have gate valves.

The OP may have some seepage around the valve. Such valves are rated for gravity flow at low head. As I said before, 480 gallons per day is not much for a 12 inch valve to leak. You could gravity flow that much through a garden hose in two or three hours with much less head.


Edited by John Fitzgerald (11/13/17 05:36 PM)
_________________________

Top
#482636 - 11/13/17 05:34 PM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: djwoodman]
Bill D. Offline


Registered: 10/19/14
Posts: 5580
Loc: Boone County Illinois
FWIW...Not saying this is the case but, if the "flapper" valve is an offset pivot disc design, it would be pressure balanced to where it would not take that much force to open it even with 20 psig water pressure against it.

The designer and/or installer of the system should be able to provide details on the valve used.


Edited by Bill D. (11/13/17 07:38 PM)
_________________________

You'll never know what ya can catch unless you wet a line!

Top
#482651 - 11/14/17 04:28 AM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: djwoodman]
dale k Offline


Registered: 02/18/13
Posts: 98
Loc: Oklahoma
Snrub
I get the same figures as you.
I do not know I think I would try and plug it. But if it starts coming around the pipe you have big problems.
Is there any way to have your diver plug off the inlet? Sorry for your troubles.

Top
#482669 - 11/14/17 11:43 AM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: dale k]
snrub Online   content


Registered: 10/05/13
Posts: 4725
Loc: SE Kansas
I sure would not want to be anywhere near the opening if someone opened a 12" valve 40' under water. It might be the divers last dive.

A 2-4" open end might be manageable. A 6" open hole operating at 17 psi negative pressure would be dangerous. Anything bigger and being within two or three feet of it when it opened would likely be fatal if it opened all at once.

Diving around lake dams always made me nervous. I know we were a quarter mile away, but you could still hear those turbines plain as day and they were not quiet under water.


Edited by snrub (11/14/17 11:44 AM)
_________________________
John

I subscribe to Pond Boss Magazine

Top
#482695 - 11/14/17 09:46 PM Re: Need help: Pond Leak with No Really Good Way to Fi [Re: djwoodman]
Rainman Offline
Ambassador
Field Correspondent
Hall of Fame

Lunker

Registered: 06/06/07
Posts: 6925
Loc: St Louis, MO area
The easiest thing to do first would be to open the valve and see if debris was blocking full closure the valve....If this lake was engineered, go to the engineer and see what the plans called for on the valve...was there and trash rack installed to prevent large limbs, etc from plugging the inlet? If not, I'd be billing the engineer for all repair work done....
_________________________
Rainman

www.TilapiaStockers.com


Top
Page 2 of 2 < 1 2

Today's Birthdays
docoman, Pharmerskip
Recent Posts
Bullhead?
by Twar
Refilling old pond
by JustinV
Tadpoles
by Twar
Facbook Live tonight 6.20.2018
by anthropic
09:33 PM
To use Japanese Beetles as feed OR not?
by teehjaeh57
08:54 PM
Bird leg fish transport
by jpsdad
08:52 PM
Quick question...
by John Fitzgerald
08:38 PM
Pond Grading Contractor...North Georgia
by bobframe
08:04 PM
Newbie to this Forum
by wbuffetjr
06:53 PM
Pond Boss Forum get together in SE Kansas
by Bob Lusk
06:40 PM
Newly Uploaded Images
Help ID this fish
Crayfish monster.
Turkey Pics
Question on pond draining
King Fisher
Tree Swallow grooming---Female Red-wing black bird

2014 POND BOSS INC. all rights reserved USA and Worldwide